This is an Internationally formulated Traffic Film remover to clean vehicles without causing any harm to the vehicle and environment. Can be used on all painted surface, windshield/ glasses, rubber and Vinyl. DIRECTIONS FOR USE Dilution Ratio 1:100. Fill 10 ml of foaming wash with 1000 ml of water. Use Tar Remover to remove all tar & adhesive marks. Foam the car and allow 2-5 minutes of contact time. Wipe with a wash mitt across the car surface to loosen all dirt. Use a wet microfiber cloth to wipe-off dirt . Use brushes near beading and edges to loosen the dirt. Wipe-off with a dry microfiber cloth for sparkling finish. STORAGE CONDITIONS Keep away from heat & sunlight. Store below 300 C. WARNINGS If product comes in contact with eyes, clean with water immediately. If swallowed , do not induce vomiting, seek medical advice.

Spray Grease is a tacky Synthetic oil specially formulated for instant maintenance and protection of vehicle. Non-dripping, non – staining with excellent penetrating property. Sprays like oil and sticks like grease. Generates tacky, long lasting lubricating film. Through pinpoint application, difficult to reach parts can be lubricated. Area of applications: Door locks, hinges, wires, bearings, open gears etc. Squeaking joints in automobiles balance rod of steering wheel. Many more areas that require long term lubrication & protection. DIRECTIONS FOR USE Shake well before use. Turn spray value so that tip points to dot on can rim. Spray directly on parts to be lubricated For hard – to – reach areas or small surfaces, use the extension tube that fits into the spray tip. After use, turn can upside down and press tip until spray is free of material STORAGE CONDITIONS Keep away from heat & sunlight. Store below 30o C. WARNINGS DANGER: Harmful or fatal if swallowed. Pressurized container. Keep away from children & flame. Do not puncture or incinerate. Avoid eye, skin contact & breathing of vapors, provide adequate ventilation If product comes in contact with eyes, clean with water immediately. If swallowed, do not induce vomiting, seek medical advice

Electrical Contact Cleaner is a quick dry, non – ozone depleting cleaner that removes, dirt, oil, grease from sensitive equipment & precision instruments without leaving any residue. This formula is safe on most plastic and is packaged in an aerosol with extension tube for hard to reach areas. Solvent type spray used for cold cleaning. Extends the operational life of the substrate, reduces downtime & helps in maintenance. Cleans dust, dirt, carbon oxide deposits, flux, rust, grease, oil & other common contaminants. Restores resistance values & electrical properties. Suitable for electrical equipment & components like electric motors, contractors, relays, solenoids, carbon bushes, battery terminals, switch gears & similar electrical equipment, machinery and automobiles. DIRECTIONS FOR USE Shake well before use. Hold the can in a position where the nozzle is pointed towards application area. Spray and leave for few seconds and wipe off with a clean cloth or brush STORAGE CONDITIONS Keep away from heat & sunlight. Store below 30o C. WARNINGS DANGER: Harmful or fatal if swallowed Pressurized container. Keep away from children & flame Do not puncture or incinerate. Avoid eye, skin contact & breathing of vapors, provide adequate ventilation If product comes in contact with eyes, clean with water immediately. If swallowed, do not induce vomiting, seek medical advice